Hardware Setup

Pan Tilt set up

Steps for setting up AXIBO's Pan Tilt unit

1. Take Pan Tilt out of the case

2. Screw the Pan Tilt unit onto the tripod/fixture until secure

3. Loosen the Knurl knobs at the back of the unit

4. Move the axes into the desired position

5. Tighten the Knurl Knobs

6. Next Step take the Controller and attach it to the tilt unit by sliding it in

7. Secure the controller with the latch

8. Set up the camera plate by loosen the side knob and setting it up as such

9. Line up the rail with the grove in the Tilt, turn the screw in to attach the Camera plate onto the AXIBO Pan Tilt

10. Plug the curly short curly cables into the Pan and Tilt axes

11. Plug the other ends into the controller" Note: Do Not plug the cables into the bottom port that is to connect AXIBO to the internet with either

12. Attach the antennas to the controller

13. Attach camera by screwing the red knurl knob

14. You can then power your AXIBO on. there are two ways . the first it to plug it in with the wall plug that comes along with AXIBO Pan Tilt, or you can power it with NPF batteries

15. Your AXIBO Pan Tilt unit is now ready to connect you can also plug in additional cables such as HDMI and a trigger cable

16. if you want to leave AXIBO plugged in but turn it on or off, then hold down the up and down buttons on the controller

Ethernet set up

1. Plug your ethernet into the back of your internet router.

2. Plug the other end into the bottom sliver port of your AXIBO NOTE: DO NOT plug the ethernet into any of the other ports, ethernets carry power and can damage your controller board

Slider set up

Setting up your AXIBO Slider

1. Unlock the slider legs

2. Adjust to desired position and then lock the leg by closing the leg lock

3. Now you can attack your AXIBO Pan Tilt unit to the slider

4. line up the arrow on the top of the Pan unit with the diamond on the slider's carriage. NOTE: make sure that the knob on the pan is tightened to mount it. Once your Pan Tilt is fixed make sure that you loosen the bolt. If the pan bolt is not loosened it will jam in operation.

5. turn the red knurl knob at the bottom until the AXIBO is secured properly

6. Plug in the cable to the AXIBO controller. Your Axibo is now ready to use

Focus Setup

1. Take the focus ring, put it onto the lenses, line the gear up with the clasp and slide it in

2. Make sure the Focus motor is loosed before you slide it onto the rod

3. Slide the Focus motor onto the rod and line up with the focus ring

4. Turn the focus until the gears teeth line up with the focus ring

5. Tighten focus knob

6. Plug the cable into the Focus motor and then into AXIBO

Changing slider motor

1. Turn the slider over and locate the 2 fasteners holding the motor in place

1. Take a 5mm Allen key and remove the bolts

1. Take the motor off. If having trouble getting it off twist the motor down to get out

2. Put the high-speed drive in by putting the pulley in the belt and turning it up

1. Put the fasteners in and tighten them all the way

1. Turn over and plug into Axibo controller